Specifications

AVIDdirector-M2M™ Technical Reference Guide
February 5, 2009 ©AVIDwireless 2004-2009 All Rights Reserved Page 49 of 55
DO NOT INTERRUPT programming the device or it may corrupt the PSoC Flash and
require sending your unit back to the factory for reprogramming.
During programming the SYSTEM STATUS light will indicate the progress.
It will rapidly blink RED during Flash programming and rapidly blink GREEN when
verifying the programming. When done, if successful it will blink GREEN twice or
if unsuccessful it blinks the error code using the RED LED three times.
It will then reboot your device.
Some Error Codes are:
1 RED blink means the Programming file did not verify correctly.
2 RED blinks means the file had a checksum error in it.
If the RED LED blinks 6 or more times, your PSoC processor is non functional and you will
have to contact AVIDWireless for assistance or return the device.
Are you sure you want to reprogram the PSoC using file psoc.hex? Answer Y or N
You entered :Y
Programming PSoC using file psoc.hex with 72538 bytes.
You will not see any other message until the device reboots.
The SYSTEM Led will begin to quickly flash Red during the programming, and then quickly flash Green
during the verification. The total time should be less than 2 minutes for both operations. If the
reprogramming was successful the SYSTEM Led will blink Green twice and then the unit will reboot. If
there was an error the SYSTEM Led will slowly blink Red. The number of times it blinks is important and
used to indicate the cause of the error. It will blink between 1 to 6 times and then repeat one. It will not
reboot the device if unsuccessful.
3. Device reboots
Imsys SNAP restarting @ Tue May 3 18:40:21 2005
Reading /system/ish.ini: [OK]
Reading /system/snap.ini: [OK]
Serial server: [OK]
JVM startup: [OK]
Setting host name: [OK]
TCP/IP startup: [OK]
FTP server: [DISABLED]
Telnet server: [DISABLED]
Setting timezone to: CST
Reading /system/startup.ini: [SKIPPED]
You may run the ‘testhw’ program again and the ‘version’ command to see the version of PSoC firmware
on the device.
> testhw
AVIDdirector-M2M Hardware API Tester Ver. 1.31.13, 3/29/05 12:07p
Enter "command" port pin value where "command" is one of:
read, write, setdin, setdout, setain, setaout [PORT] where
PORT is TTL1-6, HVC1-4, SERIAL2RX/TX/RTS/CTS, EXT1-3 or the PSoC port and pin
Other commands are: program, reset, led [System,Radio], memory, version, quit
TestHWAPI > ver
AVIDdirector-M2M Hardware API Tester Ver. 1.31.13, 3/29/05 12:07p
M2M_IO Rev. 24.4.8
ADM2MLib Ver. 1.21.7, 2/21/05 8:50p Rev: 31.5.6
PSoC Firmware Ver. 0104 ß Version of PSoC Firmware
TestHWAPI > quit
Exiting TestHWAPI