Specifications

AVIDdirector-M2M™ Technical Reference Guide
February 5, 2009 ©AVIDwireless 2004-2009 All Rights Reserved Page 29 of 55
Appendix 1 – AVIDdirector Model 100 (see Appendix 9 for Model
200) Pin and I/O Definitions
External Connector Pin Definitions
AVIDdirector-M2M model 100 board has a Phoenix 5.08mm model1757349 for the 12 position GPIO and 1757242
for the 2 position power connector.
Pin SensorLogic
Address
V Range Features PSoC Port (Pin)
Digital/Analog Connector
1 TTL1 5V TTL
Dig I/O; Analog In/Out P0.2 (77)
2 TTL2 5V TTL
Dig I/O; Analog In/Out P0.3 (99)
3 TTL3 5V TTL
Dig I/O; Analog In P0.0 (74)
4 TTL4 5V TTL
Dig I/O; Analog In P0.1 (3)
5 TTL5 5V TTL
Dig I/O; Analog In (12 bit) P2.0 (68)
6 TTL6 5V TTL
Dig I/O; Analog In (12 bit) P2.1 (7)
7 Ground
8 HVC1 0 to Vsup or Vrail
High Volt & Cur; Dig I/O; Analog In / 4 P2.2 (69)
9 HVC2 0 to Vsup or Vrail
High Volt & Cur; Dig I/O; Analog In / 4 P2.3 (6)
10 HVC3 0 to Vsup or Vrail
High Volt & Cur; Dig I/O P4.0 (63)
11 HVC4 0 to Vsup or Vrail
High Volt & Cur; Dig I/O P4.1 (11)
12 Vrail IN or Vsup OUT
J1 in sets Vsup OUT to either 5 or 12
VDC
Serial Connectors
Serial0 TTL (3-wire)
Console port on debug header P1.2(45); P1.3(29)
Serial1 RS-232 (6-wire)
DB-9 connector. P6.0-P6.7 (86-93)
Serial2 TTL (4-wire)
RJ-12 connector; TX; RX are Dig I/O;
Analog In/Out; RTS; CTS are Dig I/O
P0.4(79); P0.5(97);
P0.6(81); P0.7(95)
Serial3 TTL (6-wire)
Radio port P6.0-P5.7 (20-23;
52-55); P4.6(67);
P4.7(8)
Power Connector
1 8 to 16 VDC
Automotive grade input
2 Gnd