Owner`s manual
45
Appendixes
Result Codes
When the MultiDSU64K receives an AT command from the terminal
or PC, the MultiDSU64K tries to execute the command, then sends
a status message to the PC or terminal which reports the
"results"
of
the command (hence the name
"result codes"
). The MultiDSU64K
provides you with several responses, or
“Result Codes”
, that provide
visual responses during Command mode operation. These Result
Codes, when activated by an AT command are displayed on your
video monitor.
ATQ0
enables Result Code display; and entering
ATQ1
disables Result Code display.
You can choose to have these Result Codes displayed in either
“verbose”
(full words) or
“terse”
(digits) format. This is controlled by
the
ATV0
(terse) or
ATV1
(verbose) commands. The MultiDSU64K
defaults to verbose format.
MultiDSU64K Result Codes
TERSE VERBOSE
0OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
5 NO ANSWER
6 NO DIALTONE
7 REDIAL
8 DIAL IN PROGRESS
9 DOWNLOAD SUCCESS
10 DOWNLOAD FAILURE
11 REMOTE CONFIGURATION LOCKED