User guide

Part 6 – Commands for GPS-Enabled Devices Chapter 16 – Commands for GPS-Enabled Devices
Universal IP AT Commands Reference Guide (Document S000457H) 86
Chapter 16 – Commands for GPS-Enable
Products
#GPSSERV – Set GPS Host Server Address
Definition: This command sets the server IP address or name to which the GPS data will be sent.
Syntax: Set Value: AT#GPSSERV="<value>"
View Value: AT#GPSSERV? or AT#VGPS or AT#VALL
Values: 32-bit number in dotted-decimal notation (i.e., xxx.xxx.xxx.xxx) or
Alphanumeric ASCII text string up to 120 characters if DNS is available. No default.
Responses: OK
Otherwise ERROR
#GPSPORT – Set GPS Host Port
Definition: This command sets the GPS host port (TCP, UDP).
Syntax: Set Value: AT#GPSPORT=<port number>
View Value: AT#GPSPORT? or AT#VGPS or AT#VALL
Values: 1 to 65535
Default: 0
Responses: OK
Otherwise ERROR
#GPSPROTO – Set GPS Host Protocol
Definition: This command sets the server protocol that the GPS will use (TCP, UDP).
Syntax: Set Value: AT#GPSPROTO=<value>
View Value: AT#GPSPROTO? or AT#VGPS or AT#VALL
Values: 0 UDP
1 TCP
Default: 0
Responses: OK
Otherwise ERROR
#GPSPREFIX – Set GPS Message Prefix
Definition: This command is used to set a unique identification for each device or vehicle.
Syntax: Set Value: AT#GPSPREFIX="<value>"
View Value: AT#GPSPREFIX? or AT#VGPS or AT#VALL
Values: Up to 4 characters in an alphanumeric string
Note: The prefix is appended to the NMEA message before transit
Default: " "
Responses: OK
Otherwise ERROR