User guide

Part 4 – Commands for the SocketModem iCell, SocketModem IP, and MultiModem iCell Chapter 14
Universal IP AT Commands Reference Guide (Document S000457H) 80
#GPRSCID – Set PDP Context Identifier
Definition: #GPRSCID is the PDP context identifier which specifies a particular PDP context definition. This
parameter is local and may be used in other PDP context-related commands.
Syntax: Set Value: AT#GPRSCID=<value>
Get Value: AT#GPRSCID? or AT#VGPRS, AT#VALL
Values: Numeric between 1 and 4 inclusive.
Default: 1
#GPRSMODE – Activate Switching Between GSM and GPRS
Definition: #GPRSMODE configures the activation of the software for switching between GSM and GPRS.
Syntax: Set Value: AT#GPRSMODE=<value>
Get Value: AT#GPRSMODE? or AT#VGPRS, AT#VALL
Values: 0 Configured for GSM use.
1 Configured for GPRS use.
Default: 1
Display Commands
#DISPLAYIP – Display IP Addresses
Definition: This command allows the attached host to view the attributed IP addresses that have been
attributed during the IPCP phase of the PPP negotiation. Both local and remote PPP peer IP
addresses are displayed. This command should be issued only once the PPP OK message has
been received from the TCP/IP stack.
Syntax: AT#DISPLAYIP
Response: MY IP: xxx.xxx.xxx.xxx
PEER IP: xxx.xxx.xxx.xxx
Values: Read Parameters:
PPPMYIP
PPPPEERIP