User guide

Part 4 – Commands for the SocketModem iCell, SocketModem IP, and MultiModem iCell Chapter 14
Universal IP AT Commands Reference Guide (Document S000457H) 73
#ATCMD – Set Default Dial Time AT Commands
Definition: This command allows the user to customize AT commands on dial up.
Syntax: Set Value: AT#ATCMD=id,"Valid AT command"
View Value: AT#ATCMD=id or AT#VALL
id: Enter a Profile Setting: 0, 1, 2, 3 {0,1,2,3}
Values: Set the valid AT command (Do not include AT or issue &F, as the command will error)
Defaults: For Analog Devices: 0, "-STE=1"
1, "+MS=V34"
2, ".."
3, ".."
For All Other Devices: 0, ".."
1, ".."
2, ".."
3, ".."
#REDIALCOUNT – Set Connection Attempts Allowed
Definition: This parameter indicates how many unsuccessful connection attempts the TCP/IP stack software
will make before terminating the connection attempt activity.
Syntax: Set Value: AT#REDIALCOUNT=<value>
Get Value: AT#REDIALCOUNT? or AT#VPHY, AT#VALL
Values: Integer between 0 and 14, inclusive.
If the value is set to 0, the TCP/IP stack software will not make any call retry.
Default: 5
#REDIALDELAY – Set Call Retry Delay
Definition: This parameter controls the delay (in seconds), if any, that will exist between each call retry.
Syntax: Set Value: AT#REDIALDELAY=<value>
Get Value: AT#REDIALDELAY? or AT#VPHY, AT#VALL
Values: Integers 0 and 5–14 inclusive.
If this parameter is configured to zero, the TCP/IP stack software will attempt another connection
immediately after terminating the previous unsuccessful attempt.
Default: 5