User guide

Part 3 – Commands Wi-Fi Devices Chapter 13 – WLAN Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
Universal IP AT Commands Reference Guide (Document S000457H) 65
#WLANUSEPROFILE – User Profile
Description: Sets and displays the use profile value. If user profile value is set to any value between 1 and 4,
then at the time of user name association, the module first scans for the selected user profile
parameters.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANUSEPROFILE=<value>
View Value: AT#WLANUSEPROFILE?
Values: 1 – 4
#WLANGETRSSI – Received Signal Strength
Description: This command displays the current received signal strength.
Syntax: Set Value: AT#WLANGETRSSI
Response Values: Return a signal strength value from -256 to 255.
Example: AT#WLANGETRSSI
RSSI : 0
OK
#WLANACTIVATE – Move Module out of Power Save
Description: This command moves the module out of Power Save during an active connection. See
#WLANDOZE
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANACTIVATE
Values: NA
#WLANROAM – Enable/Disable Roaming
Description: This command enables/disables automatic roaming of the module when the wireless connection
is lost by the Access Point.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANROAM
Values: 0 Disable Auto Roam
1 Enable Auto Roam
Default: 1
#WEP64KEY – Keys for WEP64 Security Mode
Description: Sets keys for WEP64 Security mode.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WEP64KEYn ="<value>"
View Value: AT#NWEP64KEYn?
Values: ASCII text string of 10 hexadecimal characters. Valid characters include 0-9, a-f or A-F
Default: 6162636465