User guide

Part 3 – Commands Wi-Fi Devices Chapter 13 – WLAN Commands for the SocketWireless Wi-Fi (MT810SWM-IP)
Universal IP AT Commands Reference Guide (Document S000457H) 62
Country Code France:
AT#WLANCOUNTRYCODE="DOMAIN_FRANCE"
Supported Channels - Channel 10 to channel 13
Country Code MKK:- JAPAN
AT#WLANCOUNTRYCODE="DOMAIN_MKK"
Supported Channels - Channel 14
Default: DOMAIN_FCC (For US)
#WLANSCANMODE – Scanning Mode
Description: Sets scanning mode. The module can work in both active scanning and passive scanning modes.
In active scanning, the module actively sends a probe request to associate with the AP, and in
passive scanning, the module waits for a beacon from the AP and then it associates.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANSCANMODE =<value>
View Value: AT#WLANSCANMODE?
Values: 0 Active scanning
1 Passive scanning
Default: 0 Active scanning
#WLANSSID – SSID of WLAN
Description: Sets the WLAN network SSID.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANSSID ="<value>"
View Value: AT#WLANSSID?
Values: Alphanumeric ASCII Text String of up to 32 characters. It will take a blank space also.
Default: mt810swm_disable
#WLANDATARATE – WLAN Transmission Data Rate
Description: Sets the WLAN transmission data rate. "Auto" can be used for auto data rate during data transfer.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANDATARATE=<value>
View Value: AT#WLANDATARATE?
Values: Auto, 1, 2, 5.5, 9, 11, 12, 24, 36, 48, 54 (in Mbps)
Default: 11 (in Mbps)
#WLANIBSSCHANNEL – Channel for Ad-Hoc Mode
Description: Sets channel for Ad-Hoc mode.
Note: The module must be reset to put the command into effect.
Syntax: Set Value: AT#WLANIBSSCHANNEL=<value>
View Value: AT#WLANIBSSCHANNEL?
Values: 1 – 13
Default: 9