User guide

Part 2 – Commands for the SocketEthernet IP Chapter 8 – General Commands for SocketEthernet IP (MT100SEM-IP)
Universal IP AT Commands Reference Guide (Document S000457H) 49
Display Commands
#ETHIFSTATUS – View Network Interface Settings
Description: Display the address settings.
Syntax: AT#ETHIFSTATUS
Values: None
Display Example: INTERFACE: UP
LINK: UP
IPADDR: 192.168.2.3
IPGATEWAY: 192.168.2.1
IPNETMASK: 255.255.255.0
MACADDR: 00:00:00:00:00:00
DNSSERV1: 0.0.0.0.
DNSSERV2: 0.0.0.0.
DNSSERV3: 0.0.0.0.
DNSSERV4: 0.0.0.0.
#VDNS – Display Configuration of DNS Servers
Description: This command the TCP/IP stack to display all AT# parameters related to the configuration of the
DNS servers. Note: This is displayed only when DHCP is OFF.
Syntax: View: AT#VDNS
Values: None
#VIP – View Address Settings
Description: Displays the address settings.
Notes: This command displays the programmed IP settings. To see IP settings in use, including
DHCP parameters, use the #ETHIFSTATUS command.
Also, this command shows valid results only when DHCP is OFF. Otherwise, it displays the
default or stored values.
Syntax: AT#VIP
Values: None
Display Example: The order and content is as follows:
DHCP (Enable/Disable)
IP address
Subnet Mask
Default Gateway
Speed setting (see #EMACSPD command)
MAC address