User guide

Part 1 – Commands for All Universal IP Devices Chapter 1 – General AT Commands for All Universal IP Devices
Universal IP AT Commands Reference Guide (Document S000457H) 20
+IFC – Set Flow Control
Description: Turns flow control on and off.
Syntax: AT+IFC=<flow control value>
Values: 0,0 Flow Control Off
2,2 Hardware Flow Control On
Default: 2,2 Hardware Flow Control On
+IPR – Set Serial Speed
Description: Sets the serial speed.
Syntax: AT+IPR=<serial speed value>
Values: 300 to 921600
Display: AT+IPR? Displays the current serial speed.
AT+IPR=? Displays a list of all possible values (serial speeds).
Default: For All Products: 115200
#AUTORESET - Reset the Processor at a Given Time
Definition: Set an amount of time when the modem will reset after no input has been detected on the serial
port. Note: This command is not supported on the MT100SEM.
Syntax: Set Value: AT#AUTORESET=<time in minutes>
View Values: AT#AUTORESET? or AT#VALL
Values: 0-65535 the time in minutes
From 1 to 5 numeric digits (0 to 9).
Default: 0
#DELFLASH – Erase Flash Memory Parameter Values
Definition: This command erases the contents of the flash memory and loads with defaults values.
Syntax: AT#DELFLASH
Values: No parameter values.
#LEGACYMODE – Legacy Mode Enable/Disable
About Legacy Mode:
Note: This command is for all devices except the SocketEthernet IP (MT100SEM-IP)
Legacy mode allows for smoother transition to TCP/IP based connectivity from standard analog
interface connections.
When #LEGACYMODE=1, the stack will be in pseudo legacy mode where the commands &S,
&D, &C, A, D, S0, E, V operate independently of the stack. The commands will be saved to a
different NVRAM location and will not affect the IP stack once legacy mode has been exited.
Once in legacy mode, the user can configure the #TCP values and issue an ATD command to
make a connection to the remote host. If necessary, the user can also issue
ATDxxxxxxxxxxxxppppp where x is the decimal address and ppppp is the remote port. The stack
will perform the physical connection and present the user with the proper messages:
NO CARRIER