User guide

Part 1 – Commands for All Universal IP Devices Chapter 1 – General AT Commands for All Universal IP Devices
Universal IP AT Commands Reference Guide (Document S000457H) 17
Chapter 1 – General AT Commands
for All Universal IP Devices
Set Commands
AT – Command Mode
Description: If the modem responds OK to the command AT, the modem is in command mode.
E – Turn Echo ON/OFF
Description: Use this command to turn ON/OFF echoing command at the serial terminal.
Syntax: ATE
Values: ATE0 & ATE turn echo off.
ATE1 turns echo on.
I – Identification
Description: Displays identification parameters.
Syntax: ATI<value>
Responses: For MT100SEM: "1.00 to 1.00g"
For MT810SWM-IP: "1.xx" (Note: "xx" is the number.)
OK
Values: ATI3 – Identifies the firmware version.
Example: Version:MT810swm Release V1.0 (12-August-09)
OK
ATI5 – Identifies the country.
Example: "B5" (MT100SEM example)
V – Terse or Verbose
Description: Sets terse or verbose responses.
Syntax: ATVx where x=0,1
Values: ATV0 Sets terse
ATV1 Sets verbose
Display: ATV? Displays the current V setting or use AT#VALL to view all settings.
Default: ATV1