Owner`s manual

MT5634ZPW-PCI
52
Owner’s Manual
Result Codes
In command mode the MultiModemZPW-PCI sends result codes
to your computer to provide you with on-going information during
dialing and connection. The following table shows the available
result codes.
Terse Verbose Description
0OK Command executed
1 CONNECT Modem connected to line
2 RING Ring signal detected
3 NO CARRIER Carrier signal lost or not
detected
4 ERROR Invalid command
5* CONNECT 1200 Connected at 1200 bps
6 NO DIALTONE No dial tone detected
7 BUSY Busy signal detected
8 NO ANSWER No answer at remote end
10* CONNECT 2400 Connected at 2400 bps
11* CONNECT 4800 Connected at 4800 bps
12* CONNECT 9600 Connected at 9600 bps
13* CONNECT 14400 Connected at 14400 bps
14* CONNECT 19200 Connected at 19200 bps
24* CONNECT 7200 Connected at 7200 bps
25* CONNECT 12000 Connected at 12000 bps
26* CONNECT 16800 Connected at 16800 bps
40* CONNECT 300 Connected at 300 bps
55* CONNECT 21600 Connected at 21600 bps
56* CONNECT 24000 Connected at 24000 bps
57* CONNECT 26400 Connected at 26400 bps
58* CONNECT 28800 Connected at 28800 bps
59* CONNECT 31200 Connected at 31200 bps
70* CONNECT 32000 Connected at 32000 bps
60* CONNECT 33600 Connected at 33600 bps
71* CONNECT 34000 Connected at 34000 bps
72* CONNECT 36000 Connected at 36000 bps
73* CONNECT 38000 Connected at 38000 bps
74* CONNECT 40000 Connected at 40000 bps
75* CONNECT 42000 Connected at 42000 bps
76* CONNECT 44000 Connected at 44000 bps