Owner`s manual

MultiMobile 91
Chapter 6—Appendix
Compliance with BABT Requirements
Approved for connection to telecommunications system specified in the
instructions for use subject to the conditions set out in them.
Warning: Interconnection directly, or by way of other apparatus, of ports
marked SAFETY WARNING see instructions for use with ports marked
or not so marked may produce hazardous conditions on the network.
Advice should be obtained from a competent engineer before such a
connection is made.
The power required by the host and the total of all adapter cards installed
within the host environment, together with any auxiliary apparatus, shall
not exceed the power specification as stated in the Technical Reference
Material of the host apparatus.
The power requirements for this MT56128ZLX-ST: Modem Operating
Voltages: +5V, =5%, 290mA
Modem Power Consumption = 1.45W
It is essential that the PC card is fitted only in a compatible slot designed
for PC cards/PCMCIA cards, containing only Safety Extra Low Voltages
(SELV). Under normal conditions, the SELV limit is 42.2V peak a.c. or 60V
d.c. If you have any doubt, seek advice from a competent engineer before
installing the card.
This apparatus has been approved for the use of the following facilities:
 Auto-calling
 Loop disconnect and MF dialing
 Modem and facsimile features
 PBX operation
 High Speed Data and Fax performance
European Low Voltage Directive
When correctly installed and maintained, the modem will present no
hazard to the user. When correctly installed the modem will be connected
to the PSTN or a PW and to a Data Terminal Equipment (DTE), whose
modem connections comply with ITU recommendation V28. The DTE
connections are therefore taken to be safe voltages (less than ± 30 volts).