Owner`s manual

MultiMobile 73
Chapter 6—Appendix
S-Register Summary
S-registers are sections of memory where values are stored that affect how
the TA operates. They are called S-registers because each begins with the
character S. Use the S command to assign a value or to read the current
value of an S-register.
To assign a value to an S-register, use the command Sr=N where r is the
register number and n is the value to assign to the register. Example: S7=45.
To read an S-register value, use the command Sr? where r is the register
number. Example: ATS7?
S-REGISTER RANGE DEFAULT DESCRIPTION
SO 0-255 0 Sets number of rings before modem answers
S1 0-255 0 Counts rings that have occurred.
S2 0-255 43 Sets Escape Code character (default: + sign)
S3 0-127 13 Sets RETURN character (default: CTRL M)
S4 0-127 10 Sets LINE FEED character (default: CTRL J)
S5 0-23,127 8 Sets BACKSPACE character (default: CTRL H)
S6 Determines wait time for dial tone
2-65 2 International version
4-65 4 Japanese version
S7 Determines wait time before going off-hook
2-255 50 International version
35-59 50 Japanese version
S8 0-65 2 Sets pause time of comma in dial command
S10 1-255 20 Sets wait time before going off-hook after
loss of carrier
S11 50-150 95 Sets duration and spacing in tone-dialing
S12 0-255 50 Sets time for escape character to be valid
S28 0-255 1 Enables/disables V. 34
0: disabled
1-255: enabled
S30 0-90 0 Sets time for inactivity timer to disconnect