Owner`s manual

68 MultiMobile
Chapter 6—Appendix
COMMAND OPTIONS FUNCTION & DESCRIPTION
ATA Go off-hook (answer incoming call immediately)
ATB? Display V.110 user rate for outgoing calls
AT B nn=0 V.110 user rate: 600 bps
n=1 V.110 user rate: 1200 bps
n=2 V.110 user rate: 2400 bps
n=3 V.110 user rate: 4800 bps
n=4 V.110 user rate: 9600 bps
n=5 V.110 user rate: 19200 bps
n=6 V.110 user rate: 38400 bps
n=7 V.110 user rate: 48000 bps
n=8 V.110 user rate: 57600 bps (for Japan only)
ATD <number> Dial ISDN phone number
ATD <number> Make ISDN data calls, e.g., ATD5551000
ATDM <number> Make modem calls over ISDN line,
e.g., ATDM5551000
ATDT <number> Dial ISDN phone number, e.g., ATDT5551000
ATDV <number> Make ISDN phone voice calls,
e.g.,ATDV5551000
ATDSn Dial pre-stored phone number (n=0, 1, 2,)
Refer to AT&Zn=<ISDN_phone_number>
command for phone number storage.
ATDL Redial last ISDN phone number
ATEnn=0 Echo in command mode is disabled.
n=1 Echo in command mode is enabled.
ATH Hang up ISDN link
ATH1 Disconnect ISDN phone voice calls
ATH3 Disconnect ISDN data calls and ISDN phone
voice calls
ATH4 Restart ISDN layer 2 link. Enter this command
when SPID numbers are changed.
AT&G1 Switch from analog telephone line link to ISDN
link