Owner`s manual

MultiMobile 25
Chapter 3—Application Program Interfaces (APIs)
V.110 Protocol Configuration
V.110 is used widely in Japan and some European countries. Once you set
the proper V.110 communication mode, there is no need to configure the
V.110 data rate for the incoming calls. The PC Card auto-detects the V.110
incoming call data rates and establishes links.
Use the configuration utility or ISDN AT command to enable V.110
protocol and specify V.110 user rates (line rate). Unlike an external ISDN
TA, you dont need to be concerned about the speed matching between
DTE speed and V.110 user rate. The PC Card automatically sets the speed.
Use the following commands to enable V.110 and specify user rates:
AT!Z=6 Select V.110 protocol
ATB? Display current V.110 user rate for outgoing calls
ATB0 Set V.110 user rate = 600 bps
ATB1 Set V.110 user rate = 1200 bps
ATB2 Set V.110 user rate = 2400 bps
ATB3 Set V.110 user rate = 4800 bps
ATB4 Set V.110 user rate = 9600 bps
ATB5 Set V.110 user rate = 19200 bps
ATB6 Set V.110 user rate = 38400 bps
ATB7 Set V.110 user rate = 48000 bps
ATB8 Set V.110 user rate = 57600 bps (Japanese ISDN only)