Owner`s manual

MultiMobile 17
Chapter 2—Hardware/Driver Installation
Line Setting
Switch type: Select the ISDN switch type or D-channel protocol
Modem I/O: Specify the I/O for analog applications
Modem choice: Select the analog applications
Analog encoder: Select the encoding scheme for your analog
applications, modem over ISDN, modem over PSTN, or ISDN
Phone (voice). This setting should be consistent with the ISDN
Voice Encoding in ISDN folder in RVS COMMCenter (refer to
RVS-COM Lite for details)
Phone number: Enter the ISDN phone number(s)
SPID number: For North American use only
8. When finished, click Close.
9. Reboot your computer.
10. To make sure the PC Card driver is installed correctly:
a. Click Start, Programs, Administrative Tools (Common), and then
Windows NT Diagnostics.
b. Open the Services tab and click the Devices button. Scroll down
the Device list to locate the PC Card. If the status is Running, the
PC Card is installed correctly. If the status displays Stopped,
double check the settings in step 7 above.
11. Install the CAPI-based application program, RVS-COM Lite.
12. Your MultiModem PC Card is now installed. To trace ISDN connection
status when making ISDN connections, open status.exe at a the
system32 subdirectory (e.g., c:\winnt\system32\status.exe).
To change the I/O, IRQ, Mem, Pcmcia, Switch Type, ISDN phone
number (required in RVS-COM), click My Computer, Control Panel,
Network, and then open the Adapters tab. Scroll down the Device list
to select the device name. Click Properties change parameters. After
any setting changes, reboot the NT system.