Owner`s manual

16 MultiMobile
Chapter 2—Hardware/Driver Installation
Windows NT Installation
Since Windows NT 4.x does not feature Plug and Play, users must install
the PC Card manually.
Note: Windows NT4.x only works with CAPI. The ISDN AT command
emulation also available through CAPI. Other API modes, such as NDIS
and VCOMM, will be supported by a later release.
1. Run Windows NT.
2. Plug the PC Card into your laptops PCMCIA slot.
3. Insert the Windows NT driver disk and click Start, Settings, Control
Panel, and then double-click PC Card (PCMCIA). Note the resources
that NT allocates for I/O range, IRQ, Memory, etc. You will need this
information when you check the Adapter Settings in step 7 below.
Then click Network.
4. The Network dialog box appears. Open the Adapters tab and click Add.
5. In the next dialog box, click Have Disk. Enter the driver path and click
OK.
6. The Select OEM Option dialog box appears with the device name (e.g.
56K Modem + ISDN Adapter for CAPI) in the text box. Click OK.
7. The Setup dialog box appears. Make sure the settings for the Adapter
Setting and the Line Setting below match the settings you noted in
step 3 above .
Adapter Setting
I/O Base: Not used by any other devices
Interrupt: IRQ does not conflict with any other device
Mem: Setting is for PCMCIA attribute memory use. (Select one of
the settings.)
Pcmcia: Select CARDBUS if the PC Card is seated in the CardBus
slot. Select 365 COMP for the normal PCMCIA slot.