Owner`s manual
14 MultiMobile
Chapter 2—Hardware/Driver Installation
12. The Setup Complete dialog box appears. Make sure Yes, I want to
restart my computer now is selected, remove the Configuration Utility
disk, and click Finish. The computer reboots.
13. As the computer is rebooting, insert the MultiMobile into the
computers PC Card slot with the 68-pin connector facing the PC card
slot and the label facing up.
14. Plug the 15-pin connector into the 15-pin socket of the PC card. On the
other end of the 15-pin cable, leave the RJ-45 receptacle exposed until
ISDN connection is made. Hardware installation now is complete. The
MultiMobile is powered directly from the PC.
15. Connect the MultiMobile to the network by plugging the RJ-45 cable
into the cables RJ-45 receptacle. Plug the other end of the RJ-45 into
an available ISDN outlet.
Note: If S/T-interface ISDN network connection cable is used, the
ISDN phone cord should be connected between the ISDN network
connection cable and NT1 device.
16. The New Hardware Found dialog box appears and Windows
automatically installs the Virtual-COM port driver, the ISDN low level
driver, and the CAPI port driver. CAPI and VCOMM now are installed
successfully. If you want the NDIS functionality, go to the next section
to manually install the NDIS port driver.
17. Then the Line Status and the Dialer dialog boxes appear and minimize
to the taskbar.