Owner`s manual
MultiMobile 13
Chapter 2—Hardware/Driver Installation
Windows 95/98 Installation—VCOMM & CAPI
Before you startIn Windows 95, you MUST install the drivers before
attaching the PC Card to your laptop. If you install the PC Card first, the
operating system wont recognize the device.
1. Click Start, Settings, Control Panel, and Add/Remove Programs.
Then click Install.
2. The Install Program From Floppy Disk or CD-ROM dialog box
appears. Insert the MT56128ZLX-ST Disk 1 and click Next.
3. The Run Installation Program dialog box appears. Click Finish.
4. The Setup dialog box appears and informs you that the Configuration
Utility Setup is preparing the InstallShield Wizard (which guides you
through the setup).
5. The Welcome dialog box appears. Click Next.
6. The Choose Destination Location dialog box appears. Click Next to
install to the destination folder listed in the dialog box. (Click Browse
to install to a different folder.)
7. The Select Program Folder dialog box appears. Select a folder or type
a new folder name. Then click Next.
8. The Start Copying Files dialog box appears. Click Back to review or
change settings. To begin copying files, click Next.
9. As the files copy, the Setup Needs The Next Disk dialog box appears
and, in sequence, requests Disk 2, Disk 3, and Disk 4 (key disk). Insert
each requested disk and click OK. The driver installs with each disk.
10. The Configuration Utility window and the Com Port Change dialog
box appear. Make appropriate changes in the Com Port Change dialog
box, if necessary, and then click OK.
11. The Microsoft ISDN Accelerator Pack 1.1 dialog box appears and
asks if you want to install the accelerator pack. (This dialog box does
not appear in Windows 98 since the Accelerator Pack is already
included in Windows 98.) If it is not installed on your computer, click
Yes and follow dialog box instructions. If it is already installed, click No
and close the Configuration Utility window.