System information

Red Book for AIX Rel. 7.0 and 8.0
112 © 2006 Intuit Inc. All rights reserved.
Parameter Description
TCP Connection
Timeout
(in seconds)
We recommend setting this to the maximum setting of 999.
To configure TCP/IP parameters on HP LaserJet 5SI/5SI MX, 4000, 5000, or 8000 Series
printers:
Note: Unlike the HP LaserJet 4Si / 4Si MX printers, the HP LaserJet 5Si / 5Si
MX printer does not have a minus (-) key or an Enter key. The 5Si, 4000,
5000, and 8000 printers have a Select button instead of an Enter button.
1. Press Menu until HP MIO 1, HP MIO 2, EIO 1, or EIO 2 appears. Select the menu
based on where the card is installed.
2. Press Item. CFG NETWORK = NO appears.
3. Press the + key. CFG NETWORK = YES appears.
4. Press Select.
5. Press Item until CFG TCP/IP = NO appears.
6. Press the + key. CFG TCP/IP = YES appears.
7. Press Select.
8. Press Item. BOOTP = YES * appears.
9. Press the + key. BOOTP = NO appears.
10. Press Select.
11. Press Item. IP BYTE 1 = * appears (where * is some value).
12. Press the + key until the desired value of the first byte of the IP address appears. By
pressing and holding the + key, the value will scroll rapidly. The LaserJet 4000 printer
has a minus key to decrease the value.
13. Press Select * to save the value.
14. Press Item to continue. Repeat steps 11 - 13 to configure the remaining bytes of the IP
address.
15. Repeat steps 11 - 13 to configure the Subnet Mask bytes (SM BYTE 1=), syslog server IP
address (LG BYTE 1=), default gateway (GW BYTE 1=), and timeout (TIMEOUT=).
16. Press Online or GO.
17. Print a self test page to verify the IP settings.