User guide

3 Terminal and Telnet Management
CommPlete Communications Server 55
Put Line Out of Service
To put a line out of service, type O and press E
NTER. Type the number of the line you
want to put out of service, then press E
NTER. The message OUT OF SERVICE ap-
pears in the Status column the next time you refresh the screen.
Enable Line
To enable a line that has been taken out of service, type E and press E
NTER. Type the
number of the line you want to enable, then press E
NTER. The word INITIALIZING
appears in the Status column as the line device is enabled.
Refresh
Press F to refresh the screen with current information.
View Line Statistics
To view the statistics of a single line, type V and press E
NTER. Type the number of the
line you want to view, then press E
NTER. A screen similar to the following one
appears. After you view it, press E
SC to return to the previous menu.
Line Name : MODEM : 2A Status : WAITING FOR CALL
Current time : Aug 8, 1999 Sun 14:45:51
Connect time :
Line Parameters :
User Name :
Calling Party ID :
Network Address : 00000000
Node Address : 000000000000
Line tx throughput : 0 Line rx throughput : 0
Bytes tx to line : 0 Bytes rx from line : 0
Packets tx to user : 0 Packets rx from user : 0
Total bytes tx to line: 0 Total bytes rx from line: 0
Total dial in calls : 0 Total dial out calls : 0
<Esc>:Prev Menu <R>:Refresh <U>:Reset