User guide

RASExpress User Guide
54 CommPlete Communications Server
Line Information
Menu path: Main Menu ➔ Management of Server ➔ Line Information.
Line General Name Specific Name User Name Status
1 MODEM 2A WAITING FOR CALL
2 MODEM 2B WAITING FOR CALL
3 MODEM 2C WAITING FOR CALL
4 MODEM 2D WAITING FOR CALL
5 MODEM 2E WAITING FOR CALL
.. . .
.. . .
.. . .
20 MODEM 4D WAITING FOR CALL
21 MODEM 4E WAITING FOR CALL
22 MODEM 4F WAITING FOR CALL
23 MODEM 4G WAITING FOR CALL
24 MODEM 4H WAITING FOR CALL
D: Disconnect R: Reset Line O: Put Line Out of Service E: Enable Line
V: View Line Statistics F: Refresh N: Next Page
Esc: Prev Menu
Enter the choice:
This menu displays information about the current status of each of the RASExpress
server’s phone lines. Through this menu you can disconnect, reset, enable, put out of
service, change the settings, or view the statistics of each line.
Line
Shows the index number of each line. After you type an action letter (such as R for
Reset), you must type the number of the line that you want the action to apply to.
General Name
Shows the type of communication device that is on the line.
Specific Name
Shows the specific name for the communication device. The specific name is unique
to the device. It contains the slot number and a letter that identifies a specific device
in the slot. For example, segment line 22 (4F) is line 6 of slot 4.
User Name
Shows which users are currently online with the RASExpress server.
Status
This column shows the line type, which can be
RN, for idle; IN, for inbound; or OUT,
for outbound. It also shows the line status, which can be
WAITING FOR CALL, ON
LINE, WAITING TO CALL, CALLING BACK, OUT OF SERVICE,
INITIALIZING,
or TELNET ON LINE.
Next Page
To view more lines, type N and press E
NTER.
Disconnect Line
To disconnect a line, type D and press E
NTER. Type the number of the line you want
to disconnect, then press E
NTER. The line immediately disconnects, and the message
WAITING TO CALL appears in the Status column.
Reset Line
To reset a line, type D and press E
NTER. Type the number of the line you want to
reset, then press E
NTER. The word INITIALIZING appears in the Status column as
the line device is reset to its initial state.