User guide
RASExpress User Guide
46 CommPlete Communications Server
Board Information
Menu path: Main Menu ➔ Configuration of Server ➔ Communication Setup ➔
Multitech ISI Setup ➔ Add or Modify.
1. Base Address : 210
2. Irq : 10
3. Number of Ports : 08
Select the field to modify (ESC Prev Menu)
Use the Board Information menu to create or modify the port settings for a modem
card. The port settings consist of a base address, IRQ number, and the number of
ports on the card. To change any setting, select the option and type a new value.
Note: Setting the wrong base address and IRQ value can lead to unpredictable results.
Base Address
This is the base I/O address for the modem card in hexadecimal format. It provides
the RASExpress server with information about card activity, and allows the card to
use one interrupt for all ports on the card. There is a maximum number of three com-
munication cards in a CommPlete segment. Each card must have a unique base I/O
address number.
IRQ Number
This is the interrupt number for the modem card. An IRQ requests the attention of
RASExpress and the server’s microprocessor. The IRQ number used for each com-
munication card must be unique in the segment.
Number of Ports
This is the number of ports on the modem card.
Edit Line Information
Menu path: Main Menu ➔ Configuration of Server ➔ Communication Setup ➔ ISI
Setup ➔ Edit Line Information.
When you select Edit Line Information and select a card, the List of Lines menu ap-
pears. The List of Lines menu lists the phone lines on the selected card. Type the
number of the line you want to edit, and press E
NTER. The Line Information menu
appears. The Line Information menu lists the parameters that can be configured for
the selected port. To edit a parameter, type its number, press E
NTER, and type or
select the new value.
1. Line Status : enabled
2. General Name : MODEM
3. Specific Name : 2A
4. Modem Name : MT5634HD8
5. Connection Started By : Data Carrier Detect
6. Baud Rate : 115200
7. Data Bits : 8
8. Stop Bits : 1
9. Parity : NONE
10. RTS/CTS Flow control : enabled
Select the field to modify (ESC Prev Menu):