User guide

3 Terminal and Telnet Management
CommPlete Communications Server 27
Async Control Map (ACCM)
Type the PPP Asynchronous Control Character Map (ACCM) for the port, in the
range 0–FFFFFFFF.
Compression
Select enabled to enable PPP data compression for the port. Enable data compression
only if the data link is slower than 57,600 bps and the modem is not doing any data
compression. Disable it if the data link is 57,600 bps or faster or if the modem is doing
data compression.
Authentication Protocol
Select the PPP authentication protocol for the port. You can choose Password
Authentication Protocol (PAP), Challenge Handshake Authentication Protocol
(CHAP), or None.
User Name
Type a user name here for use in LAN-to-LAN security. For a client-to-LAN configu-
ration, leave this field blank.
User Password
Type a password here for use in LAN-to-LAN security. The password is case-
sensitive, and must match the password at the other end of the PPP connection.. For a
client-to-LAN configuration, leave this field blank.
Dial on Demand
This field is used only for LAN-to-LAN operations. Enable it if you want to discon-
nect the line during idle times and connect only when you need to transfer data. If
this option is enabled, RASExpress spoofs all watchdog and serialization packets.
IPXCP
Select enabled to enable IPX for remote dial-in clients on the port. Select disabled to
disable IPX. IPXCP is a PPP network control protocol for IPX. It is responsible for
configuring, enabling, and disabling the IPX protocol modules on both ends of the
point-to-point link.
Network Number
This field shows the IPX network number of the port. There is a unique number for
each port that does not correlate with the existing network number. You can edit this
field only if IPXCP is enabled for the port.
Node Number
This field shows the IPX remote node number of the port. Each port must have a
unique node number. You can edit this field only if IPXCP is enabled for the port.
CIPX Compression
Select enabled to enable CIPX (Compressed Internetwork Packet Exchange) compres-
sion of IPX headers for the port. Select disabled if you do not want CIPX compression.
If you select enabled, CIPX compression must also be enabled on the server for your
choice to have an effect. You can edit this field only if IPXCP is enabled for the port.
NetBIOS over IPX
This field allows you to enable or disable routing of NetBIOS over IPX packets on the
port. Enable it if you are using applications that require NetBIOS over IPX support.
You can edit this field only if IPXCP is enabled for the port.