User guide

March 2011 Page 29 of 30
Part No:FF-MCAFEE
to Connect Pushkablue Console port to Any 9 Way DB Male (DTE) connection
Pushkablue to McAfee Network Appliances Comm ports
To Pushkablue Console port
(RJ45) port (DTE)
To 9 Way D Male
Console / PC Port (DTE)
Part No: FF-DB9F
SignalPin
Pushkablue RJ45 port
Pin
2
GND 4
1
Rxd 3
Txd 6
7
GND 5
8
GND
Rxd
Txd
5
3
2
7
RTS
8
CTS
Not Connected
DTR
DSR
4
6
Rollover cable
Black
Yellow
White
Blue
Brown
Red
Orange
Signal
Rear View of Pushkablue
to PC Comm Port Adapter
9 Way D Female (Part No: FF-DB9F)
54321
987
6
B
W
McAfee Comm Port
Pushkablue Factory Default Reset
If You forget the Admin names and passwords, or you need to
reset the FF06-2P back to Factory Reset, take a paper clip or
pen and insert into the PWD Hole on the rear panel, as shown in
the diagram (Right).
You will feel a button behind the rear panel, press slowly and
you will feel the button push in.
Hold for 8 seconds, while the FF06-2P is powered up. This will
make the FF06-2P revert to Factory default.
Spare 10 Amp Fuse
The FF06-2P uses an Anti-Surge Ceramic 10Amp fuse. (T10AH 250V)
This can be located in the fuse draw of the IEC C14 Power inlet as
shown in the diagram (Right).
A spare fuse is also supplied, if required.
If further fuses are needed, please contact Pushkablue Data
Communications Ltd for advice.
Warning: DO NOT use any other fuse other than the fuse described.
In/Out
Spare Fuse
(T10AH 250V)
Operational Fuse
(T10AH 250V)
Fuse: Cooper Bussman 10 Amp Anti-Surge Ceramic
RS Componets part No: 537-1060 (www.rswww.co.uk)