User guide

March 2011 Page 20 of 30
(7) – Set Banner
You can enable a banner which will appear with the Login Prompt.
This Banner is to show unauthorised users that a prosecution will be invoked if unauthorised access is attempted.
To enable a banner, from the main menu, choose Pushkablue Setup Options,
Choose 7 Set Banner.
(Example: F<CR>, then 7<CR>)
You will be given a prompt:
Banner is Currently Disabled
Change (y/n)?
Type: Y<CR>
Another prompt will appear:
Enter Banner (Up to 254 Characters) <ESC> to end :
Type banner and press <ESC>Key when finished.
You can have up to 254 Characters and spaces are allowed and you can use <CR> to start another line.
Once finished, you will be taken back to the Pushkablue Setup Options Menu.
Other Main Menu Features
(I) Type: I<CR>,
This will refresh the Main Menu and give you the software revision information at the top of the Main menu
(L) Type: L<CR>,
This terminates the dial up connection.
(V) Type V<CR>,
This shows historical and current user activities on ports and changes of configuration.
(F) Type: F<CR>,
This enables the Administrator to configure the FF06-2P, such as prompt names, port names and port speeds as mentioned on previous pages.
This section goes into more detail later in this document on page 16
(M) Type: M<CR>,
This takes you to the Manage User section covered later in this document on page 25