User guide

March 2011 Page 14 of 30
Changing Prompt Name
(Please note: <CR> = Enter)
Abbreviated
Command
Admin 1 Admin 2
Parameters/Values
Description
PR=
 
1-32 Characters
(including spaces)
Changes the Pushkablue Prompt name
(Default: OK)
Example: pr=Pushkablue-New York
Prompt name would now show: Pushkablue-New York:
Changing Console Port and Power Port Names
Abbreviated
Command
Admin 1
Admin 2
Parameters/Values Description
CnN=
 
1 to 32 Characters
(including Spaces)
Changes Console Port
n
Name (
n
= 1 to 6)
Where n is the Console port number:
Example: C1N=Cisco 2610-01
Console Port 1 name would now show: Cisco 2610-01
PnnN=
 
1 to 32 Characters
(including Spaces)
Changes Power Port
n
nName (
n
n
=A1 or B1)
Where nn is the Power port number:
Example: PA1N=Cisco 2610-01 Power
Power Port A1 name would now show: Cisco 2610-01 Power
Split Administrator Gift Commands
The Split Administrator function allows 2 separate departments of organizations share the same Out of Band device and telephone line, but each
department cannot control or gain access to each other’s console or power ports.
ACP=
 
1;2;3;4;5;6
Allocates Console Ports to other Administrator
(Default: Not Active, until invoked by Admin 1)
Example: If logged in as Admin 1: acp=4;5;6<CR>
Console Port s 4,5 & 6, is now Gifted to Administrator 2
APP=
 
A1 & B1
Allocates Power Ports to other Administrator
(Default: Not Active, until invoked by Admin 1)
Example: If logged in as Admin 1: app=B1<CR>
Power Port B1, is now Gifted to Administrator 2
Admin 1 has to Gift console and power ports to Admin 2. Once this has been instigated, Admin 1 loses control and access to these ports.
Admin 2 can however; Gift console and power ports back to Admin 1 also. The abbreviated commands are the same for each Administrator.
From a factory default status, Admin 1 can also change the default Admin 2 name (default: SysAdmin002) and
Passwords (Default: Pushkablue, DoNotKnow). But This Can ONLY be done ONCE.
If logged in as Admin 2, you can change the Admin 2 Name and Passwords independently from Admin1.
The commands to Gift console ports and Power ports are the same for both Admin 1 and Admin 2, they are:
To Gift Console Ports, type: acp=n<CR>
(n = Console port Number)
If you are Gifting more than one console port, place a semi-colon (;) between the numbers, example: acp=1;2;3<CR>
To Gift Power Ports, type: app=nn<CR>
(nn = Power Port Number A1 or B1)
Please Note: If you are Gifting more than one Power Port, place a semi-colon (;) between the numbers, example: app=A1;B1<CR>
Once this has been done, hit<CR> 3 times quickly to refresh the Main Menu, you should see the console and
Power ports Gifted have gone from the Main Menu.