Specifications

Chapter 1 – Universal Socket Connectivity
Multi-Tech Systems, Inc. Universal Socket Hardware Guide for Developers (S000342F) 28
Recommended Parts for Non-Wireless
Modules
Disclaimer: Multi-Tech Systems makes no warranty claims for vendor product recommendations listed below. Other
vendor products may or may not operate satisfactorily. Multi-Tech System’s recommended vendor products only
indicate that the product has been tested in controlled conditions and were found to perform satisfactorily.
Surface mount ferrites are used on T&R (Tip and Ring) to mitigate emission levels out the RJ-11 cable. 220pF
capacitors are also used on T&R to reduce the common mode emissions that may be present in certain systems.
The ferrite and capacitors also aid in reducing the effects of transients that may be present on the line.
Note: These parts are RoHS compliant.
Recommended Ferrite (SMT)
Manufacturer – Associated Component Technology (ACT) Part # CBZ1206-202-30-LF
Manufacturer – Murata Erie Part # BLM31AJ601SN1L
Recommended Ferrite (Thru-Hole)
Manufacturer – Associated Component Technology (ACT) Part # WB2-2.OT
Recommended Capacitor (SMT)
Manufacturer – NOVACAP Part # ES2211N221K502NXT
Manufacturer – Murata Erie Part # GA355DR7GC221KY02L
Recommended Capacitor (Thru-Hole)
Manufacturer – Ever Grace Electronic Industrials Part # YP221K2EA7PS-8.0
Manufacturer – Murata Erie Part # DE2B3KH221KA3B
Note: Capacitors used on T&R must have the Y2 safety rating.
Recommended Connector
Manufacturer – Stewart Part # SS-64600-006F
Recommended Sidactor
Manufacturer – Teccor Electronics (LittelFuse) Part # P3100SAL
Manufacturer – ST Microelectronics Part# SMTPA270
Manufacturer – ST Microelectronics Part # SMP100LC-270
Recommended Poly Switch Thermal Fuse (SMT)
Manufacturer – RayChem (Tyco Electronics) Part # TS600-170F
Recommended Poly Switch Thermal Fuse (Thru-Hole)
Manufacturer – RayChem (Tyco Electronics) Part# TRF600-150
Note: The Fuse & Sidactor are required in order to comply with UL60950 for protection against over-voltages from
power line cross. Fuse can be reset type.
Common Mode Choke
Manufacturer – TDK Part # ZJYS51R5-2PT-01
Recommended Transceiver
Manufacturer – Analog Devices Part # ADM207EARZ
Dip Connector
Manufacturer – Specialty Electronics (www.connectorsolutions.com)
4-Pin 2.0mm SIP Socket (2 Each)
10-Pin 2.0mm SIP Socket (2 Each)
Telecom
The RJ-11 connector must meet FCC Part 68 requirements. Refer to FCC Part 68 section 68.500 subpart F for
connector specifications. A self-healing fuse is used in series with line to help prevent damage to the DAA circuit.
This fuse is required in order to comply with FCC Part 68 compliance regulations.
Note: See Application Notes at the end of each SocketModem chapter.