Owner`s manual

PN 88300150
4/3/01 85
&SF1 selects DSR independent.
$SPn n = 0 or 1 *** $SP0 disables UUCP Spoofing
$SP1 enables UUCP Spoofing
T Modem will tone-dial numbers following the T.
&Tn n = 4 or 5 &T4 means Enable Response to Request for
Remote Digital Loopback.
*** &T5 means Disable Response to Request for
Remote Digital Loopback.
#Tn n = 0 or 1 #T0 turns off Trellis Coded Modulation
*** #T1 turns on Trellis Coded Modulation
Un n = 0, 1, 2, U0 places modem in Analog Loop Originate Test Mode.
or 3 U1 places modem in Analog Loop Answer Test Mode.
U2 places modem in Remote Digital Loopback Test Mode.
U3 places modem in Local Digital Loopback Test Mode.
Vn n = 0 or 1 V0 means Result Codes sent as (terse response).
*** V1 means Result Codes sent as words (verbose response).
#Vn n = 0 or 1 #V0 enables V.32terbo.
*** #V1 disables V.32 terbo.
W Wait for new dial-tone.
&Wn n = 0 or 1 &W0 causes modem to store its parameters in non-volatile RAM, and
modem loads these for future sessions instead of reading factory ROM defaults,
unless &F command used.
*** &W1 causes modem to not store parameters.
Xn n=0 thru 4 Xo selects Basic Result w/o CONNECT 1200, CONNECT 2400)
X1 selects Extended Result (w/ CONNECT 1200, CONNECT 2400)
X2 selects Standard AT command set NO DIAL TONE
X3 selects Standard AT command set with BUSY
*** X4 selects Standard AT command set with NO DIAL TONE and BUSY
&Xn n = o thru 2 *** &X0 Sync internal clocking.
&X1 Sync external clocking.
&X2 Sync slave clocking.
#Xn n = 0 or 1 #X0 causes one XOFF to be sent until buffer reaches XON level
#X1 causes one XOFF to be sent for every character received after modem reaches
buffer full level
Yn n = 0 or 1 *** Y0 disables sending or responding to long space “break”.
Y1 enables sending or responding to long space “breaks”.
Z All configuration parameters are reset to default values.
, in Dial Causes pause during dialing.
command
; in Dial Causes return to Command Mode after dialing.
command
! in Dial Causes modem to Flash On-Hook.
command
@ in Dial Causes modem to wait for ringback, then 5 seconds of silence before processing
command next part of command.
+++AT<CR> Escape Code. Puts modem in Command Mode while remaining On-Line. Type +++
followed by the letters A and T & up to ten command characters, and hit ENTER.
BREAK AT<CR> Alternate Escape Sequence. Brings modem into Command mode while remaining On-
Line. Not preceded by AT. Type BREAK signal, followed by the letters A and T, up to
60 command characters, and hit ENTER.