Owner`s manual

PN 88300150
4/3/01 79
Appendix D
Result Code Summary
DIGIT WORDS EFFECT
“Multi-Tech” Result Codes*
0 OK Command was executed without error; ready for next command.
1 CONNECT Modem has detected carrier and gone on-line.
2 RING Modem has detected ring caused by incoming call.
3 NO CARRIER No carrier signal has been detected within allowed time.
4 ERROR Error in Command line (too many, or invalid characters).
5 CONNECT 1200 Modem has detected carrier at 1200 bps and gone on-line.
6 NO DIAL TONE No dial tone has been detected.
7 BUSY A busy signal has been detected.
8 NO ANSWER Remote system did not answer.
9 CONNECT 2400 Modem has detected carrier at 2400 bps and gone on-line.
11 CONNECT 4800 Modem has detected carrier at 4800 bps and gone on-line.
12 CONNECT 9600 Modem has detected carrier at 9600 bps and gone on-line.
13 CONNECT 14400 Modem has detected carrier at 14400 bps and gone on-line.
19 CONNECT 19200 Modem has detected carrier at 19200 bps and gone on-line.
21 CONNECT 21600 Modem has detected carrier at 21600 bps and gone on-line.
23 CONNECT 1275 Modem is connected in V.23 mode.
24 CONNECT 24000 Modem has detected carrier at 24000 bps and gone on-line.
26 CONNECT 26400 Modem has detected carrier at 26400 bps and gone on-line.
28 CONNECT 28800 Modem has detected carrier at 28800 bps and gone on-line.
Note: If the MT2834MR is used in MNP Reliable mode, the following Result Codes
change:
1R CONNECT RELIABLE
5R CONNECT 1200 RELIABLE
9R CONNECT 2400 RELIABLE
11R CONNECT 4800 RELIABLE
12R CONNECT 9600 RELIABLE
13R CONNECT 14400 RELIABLE
19R CONNECT 19200 RELIABLE
21R CONNECT 21600 RELIABLE
24R CONNECT 24000 RELIABLE
26R CONNECT 26400 RELIABLE
28R CONNECT 28800 RELIABLE
*See Note 2 for “AT Command Set Result Codes”.