Specifications

93
USING DIAL-UP • GENERAL USAGE
TECHNICAL SUPPORT 978-486-0086 • [e-mail] • www.burk.com
REPORT MODE
To determine the mode the VRC2500 is currently in, enter:
 “6 *”
The VRC2500 will respond with either operator or observer mode.
REPORT SITE NUMBER AND SECURITY LEVEL
To report the site number of the VRC2500 and the security level,
enter:
 “0 *”
The VRC2500 will respond with the site number and observer or
operator access.
REPORT FIRMWARE VERSION NUMBER
To report the firmware version number of the VRC2500, enter:
 “8 0 0”
The VRC2500 will respond with the site number and the firmware
version number for the Dial-Up.
ESCAPE/CANCEL COMMAND
The VRC2500 can be programmed to pause for a specified length
of time (See Command Delay, page 82 before issuing commands.
This gives you a chance to clear/escape entered DTMF codes
before the codes are acted on in the case of error.
To clear the VRC2500 memory command buffer, enter:
 “0 #”
The VRC2500 responds:
• C
ANCELED
New commands can now be entered.
Please refer to Appendix
A for a complete list of the
DTMF codes to use when
accessing the Voice Interface in
Voice Mode.
!