Specifications

87
USING DIAL-UP • RETRIEVING INFORMATION & ISSUING COMMANDS
TECHNICAL SUPPORT 978-486-0086 • [e-mail] • www.burk.com
Enter the following code to activate switch B:
 “2 x x #”
The VRC2500 will respond with the programmed phrase
identifying switch B and energize the selected command
channel’s switch B.
Each switch is activated after entering “*” or “#” and the
command-delay time elapses. Either symbol can be entered
several times in a row (if desired).
You can then enter additional “*” or “#” to adjust the output as
desired.
List Macros
To receive a verbal list of the macro titles and numbers, enter:
 “5 #”
The VRC2500 will respond with the macro titles and numbers if a
text description has been entered via the General Setup
Configuration window. If no text has been entered, the VRC will
remain silent.
Run Macros
To run a macro, enter the following code:
 “5 x x #”
The VRC2500 will perform the functions detailed in the macro.
Perform Data Capture
Enter the following code to perform a data capture:
 “0 4 0 *”
The VRC2500 will capture data for later reference at a logged-on
PC and say:
• U
NIT INFORMATION CAPTURED
ENDING A CALL
Sign off from the Dial-Up by entering the following code:
 “9 9 9”
The VRC2500 will respond with the programmed goodbye
message, then hang up the telephone line.
The VRC2500 will also
automatically hang up if
no codes are entered for
the user-defined number of
minutes.
✍✍
Please refer to Appendix
A for a complete list of the
DTMF codes to use when
accessing the Voice Interface in
Voice Mode.
!