Specifications

SITE MANAGEMENT • DIAL-UP SETUP
72
7 Beaver Brook Road, Littleton, MA 01460 • 978-486-0086 • www.burk.com
FIRMWARE
The Firmware utility in the Dial-Up Configure
window allows you to upgrade your current Dial-
Up firmware when new versions become
available.
1. Connect to the DIAL-UP port on your VRC2500 unit.
2. Double-click the Firmware icon in the Dial-Up Configure
window to open the Firmware Wizard. You can also right-click
on the Dial-Up icon in the Site window and select “Upload
Firmware.”
3. Continue to the Select Units tab by clicking NEXT
The FORCE option should
only be used if advised by
technical support. This
forces the version of firmware
uploaded to be based on the
address of the Unit or Voice
component, rather than the
detected device type.
✍✍
The VRC2500 comes
preloaded with current
firmware. It is not
necessary to upload firmware to a
new unit. If you are replacing
corrupt firmware or if your unit has
no firmware loaded on it, please
follow the firmware upload
procedure in the Troubleshooting
section on page 210.
✍✍