Specifications

65
SITE MANAGEMENT • GENERAL SETUP
TECHNICAL SUPPORT 978-486-0086 • [e-mail] • www.burk.com
MUTING
The Muting utility allows you to define a condition
that causes one or more Metering or Status
channels to ignore alarms, macros, or commands
that may have occurred in the unmuted state. For
example, if the main transmitter is on, you can
mute conditions on the standby transmitter.
To open the Mute window, click on the Muting icon. All previously
programmed mute states are displayed in the main area.
1. To create a new entry, select a source status or command
channel and the state to enable the mute function (e.g., Status
12 Low, Command 1B, etc.).
2. Select the metering or status input channel to be muted (e.g.,
Meter 2, Status 4, etc.).
3. Click Insert to move the mute entry into the main display
area. Upload (blue up arrow) must be clicked before the
change is loaded into the VRC unit. All entries have an icon
on the left hand side of the main view area.
To modify an existing mute entry, select the entry, make the
changes needed, and then click Update. This updates the main
view area.
To delete an unwanted mute entry, select the entry and then click
Remove. The entry is deleted from the list.
You can creat a macro to
handle more complex
mute functions.
✍✍
Mute Selection