Specifications

61
SITE MANAGEMENT • GENERAL SETUP
TECHNICAL SUPPORT 978-486-0086 • [e-mail] • www.burk.com
Getting the Date Right
If the event is to occur during a specific month, enter a value from
1 to 12 in the month area. If the event is to occur on a specific
day of each month, or of any particular month, enter a value from
1 to 31 in the day area. If no values are entered in any field, all
possible dates or times are assumed.
For example, if an event is to occur each month on the 15th, the
MM/DD entry would look like this:
If the event is to occur only on July 15th, the MM/DD entry would
look something like this:
To set an event to occur on only one day of the week, select that
day. The default is set for every day of the week.
Getting the Time Right
Specify in hours, minutes, and seconds, when this event is to take
place. In any of the three openings, if no value is entered, the
event will occur in every possible combination of times
where the values are true.
For example, if the event is to occur every hour at thirty minutes
after the hour, and only once during that hour, the entry would
look like this:
If the event was to occur at a particular hour, but execute every
second of every minute during that hour, the entry looks like this:
2. Click on the double-left arrow on the line titled ACTION. This
opens the Select an Action window. Make sure the unit you
are configuring is highlighted. Choose one of the three
possible actions - command, macro, or capture. To execute a
command and a capture in the same entry, you must create a
macro. See page 119.
The VRC2500 will handle
192 captures before
overwriting the oldest
capture to store the next one.
✍✍