Specifications

SITE MANAGEMENT • GENERAL SETUP
58
7 Beaver Brook Road, Littleton, MA 01460 • 978-486-0086 • www.burk.com
Alarm
Use the pull-down menu to choose the type of alarm you want
issued when a change in state occurs. If you do not want to
receive alarms, select None. If you want the alarms to register
and display on-screen, but do not want the VRC unit to attempt to
notify you, choose Warning. If you want to be notified of an alarm,
select Critical and the VRC unit will attempt to call out (or open
the alarm window) when the input changes state. Alarms may be
set to occur when the status makes a transition from the
predetermined optimal state to the opposite logic level.
Delay
Is the amount of time, definable to tenths of a second, that the
unit waits after the alarm condition is continuously asserted
before executing the programmed action and/or issuing an alarm.
If the input status changes back to the non-alarmed state before
the delay time has elapsed, alarms or actions will not occur at
that time.
Action
The Action Window allows you to select what kind of response
the VRC2500 unit uses whenever the specified alarm state is
achieved and the delay is exceeded. Clicking on the drop-down
menu, pops up a window allowing you to select the desired
action. An action can be executed on any unit on the G-Bus
network. Refer back to page 56 for a description of each tab in
the Action Window.