Specifications

INSTALLATION & SETUP • CONNECTING A COMMAND RELAY UNIT

7 Beaver Brook Road, Littleton, MA 01460 • 978-486-0086 • www.burk.com

2. Connect the Command Relay Unit to the I/O unit using the

provided DB37 cable. Two pins on the DB37 connector are

used to power the Command Relay unit. When your GSC or

VRC unit is powered up, verify that both power LEDs on the

back panel of the Command Relay unit are green, indicating

5VDC power.

Connecting Site Equipment to the VRC Unit Using a Command Relay Unit