Specifications

INSTALLATION & SETUP • SOFTWARE INSTALLATION
12
7 Beaver Brook Road, Littleton, MA 01460 • 978-486-0086 • www.burk.com
INSTALL
1. Boot the PC to the Windows operating system. Make sure
that all other programs or applications are closed. Insert the
VRC2500 CD into the CD-ROM drive.
2. If the Autorun feature is enabled on the PC, a window pops
up with the option to install the VRC2500 software or exit.
(See figure below.)
3. Click INSTALL to launch the InstallShield Wizard.
If the Autorun window does not open, click on the Windows
START menu and choose RUN. Type "<drive>:\setup.exe" where
<drive> is the letter of the CD-ROM drive (e.g., D:\setup.exe).
Setup launches the InstallShield Wizard.
4. The InstallShield Wizard guides you through several screens,
including Welcome, License Agreement and User Information.
Click NEXT or YES to move to the next screen or NO or
CANCEL to end the installation process.You must enter a
serial number at the User Information screen if one is not
automatically inserted.
VRC2500 Install Menu
If you are installing on a
PC running Windows NT,
you must be logged in as
the Administrator.
✍✍
Software
Installation
VRC2500 software will not
run properly if Lynx
software is installed on
your PC. The software packages
are mutually exclusive. If you are
using GSC3000 Lynx software and
VRC2500 units, do NOT install the
VRC2500 software. Abort the
installation. Use the Lynx software
to set up and operate your
VRC2500 unit(s).
!
A DCOM98 error message
pops up during installation
if the DCOM98 version on
your computer is newer than the
version included with the software
package. If you would like to use
the version included with the
software you will need to uninstall
your current version. Otherwise,
click OK and proceed with the
installation.
✍✍