Specifications

9
OVERVIEW • SAFETY INFORMATION
TECHNICAL SUPPORT 978-486-0086 • [e-mail] • www.burk.com
If you are performing maintenance on your communications
equipment, you should press the REMOTE/LOCAL button on your
VRC2500 unit to switch into Local mode. The LED indicator
changes to a solid red color. Local mode prevents the unit from
issuing command outputs. All metering and status information is
still available to remote users.
The VRC software also indicates whether a unit is in Remote or
Local mode. If the unit is in Local mode, a small padlock appears
on the General Setup icon in the Site window.
Safety
Information
Software
Requirements
WARNING! Possible
severe injury may occur if
a command channel is
activated while you are performing
maintenance on your equipment. It
is critical that you switch the I/O
unit from REMOTE to LOCAL
mode before working with
connected equipment.
!
Remote/Local Button on VRC2500
The VRC2500 software requires Windows
®
98 or Windows
®
NT 4
with Service Pack 5. If you are running Windows NT, you need
to be logged in as the Administrator before attempting to
install the software.
• Pentium 166 MHz minimum (200 MHz or higher recommended)
• Windows
®
98 or Windows
®
NT 4 w/ SP5
• 50MB free hard drive space
• 32MB RAM minimum (64MB RAM minimum for Windows NT)
• Video card capable of 800x600 screen resolution at 256 colors
(1024x760 screen resolution recommended)
• One available COM port for each direct cable connection
• 19.2kbps or faster modem
• CD-ROM Drive
• Multimedia speakers (if using the audible alarm feature)