User guide

Chapter 5 – Firmware Upgrade
MultiConnect AW User Guide 41
3. Close the terminal program.
4. Double-click the Flash Wizard icon or filename to run Flash Wizard. The Identifying Devices window displays as
the Flash Wizard locates and identifies the devices connected to your system.
Note: If the message ERROR: No valid devices detected displays, verify that the MultiConnect is turned on, that all
cables are correctly and securely attached, and the correct COM port is being used.
5. Click to highlight the model and click Next.
6. Click the port to be upgraded from the Port list and click Next.
The Progress dialog box appears, showing a status bar that indicates the progress of the upgrade.
Caution: Disrupting the Flash Wizard during this stage of the upgrade may make your unit inoperable.