User guide

18 Multi-Tech Systems, Inc. MultiConnect AW User
Guide
Chapter 2 – Installation
Account Activation for Wireless Devices
Please refer to Multi-Tech’s Cellular Activation Web site at http://www.multitech.com/activation.go for
information on activating your cellular modem. On the Cellular Activation Web site, click the down arrow in
Select Your Product and select the desired model of MT200A2W from the pull down listing.
Insert the SIM Card into Holder
This section applies to models MT200A2W-G and MT200A2W-H5.
The MultiConnect requires the power supply connection to begin operation. It also requires a SIM card
(Subscriber Identity Module) in the unit to operate on a GPRS/GSM and HSPA+ network. To install the SIM,
perform the following procedure:
1. Before changing a SIM, ensure that power is removed from the unit.
2. Open the SIM door by pressing down on the tab on the top of the door and prying open the door.
3. Insert the SIM card into the card holder. The above graphic illustrates the correct SIM card orientation.
4. Verify that the SIM card fits into the holder properly and then close the door.
Connect the Antenna, Serial and Modem Cables, and Power
Dial Port Caution
The dial port is not designed to be connected to a Public Telecommunications Network (PSTN/phone
line) or used outside the building.
Composez Port Attention
Le cadran port n'est pas conçu pour être connecté à un réseau de télécommunication publique (PSTN / de ligne
téléphonique) ou utilisé à l'extérieur du bâtiment.