Manualshelf

User`s guide

ManualsBrandsMultitech ManualsComputer equipmentMT1932ZDXI
61626364656667686970
Page 68
9.1.2 Part 2
GSM2102 General 12-02-01 12.00.00
Ver 6.13 USERID SYSNAME
Type values and press Enter
Use blank as separator charact 1 0=No, 1=Yes
Additional separator character #
Rejected message receiver . . USERID____
Keep messages . . . . . . . . 90 Days
Keep communication logs . . . 30 Days
Exit command string . . . . . SNDGSMTBRK USID(&U) MTXT(&M)________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
______________________________________________________________________________
________________________________________________________________
F12=Cancel
General Configuration part 2
Use blank as separator character
This field controls if blank shall be used as separator character between the
command code and between the parameters in incoming messages. Specify
0 for no, and 1 for yes.
Additional separator character
If desired, specify the additional separator character to be used.
Rejected message receiver
This field specifies the id of the receiver to be notified if an incoming
message has been rejected. A message will be rejected if the command
code is unknown, or if the user is not authorised to use it.
*NONE Function is not active.
*SYS The notification message will be sent to the same user as is
specified to receive operational messages for this system.
User id The id of the user or distribution group who shall receive the
notification message.
Keep messages
The number of days during which messages (outgoing and incoming) are
kept on the system. Thereafter they will automatically be deleted when the
subsystem is started.
Keep communication logs
The number of days communication logs are kept in out queue GSMTEXT in
library GSMTEXT. Thereafter they will automatically be deleted when the
subsystem is started.
Exit command string
Specify the command that shall be run when the exit command function is
activated. It can be any valid user or system command. The following
describes the variables and values returned for the substitution parameters:
&U User id in the user file.
&M The text content of the message.