System information

Figure 119. Windows NT Setup Manager (SETUPMGR.EXE)
By clicking on Network Options you can define the network transport protocol the
system should use and select an adapter card. Usually it′s best to let the
system autodetect the card.
Figure 120. Windows NT Setup Manager - Network Options
Note
You can not define an IP address for a specific system in the Setup Manager.
If your system does not use DHCP Service, you have to set up the
information in the file %systemroot%\system32\IPINFO.INF. Each target
machine will require a unique IP address in the IPINFO.INF file. Read the
header of this file for more instructions.
If any information needed by the setup process is omitted, the setup program
will prompt the user to provide this information. A copy of the comments from
the IPINFO.INF file is shown below:
Chapter 2. NT Systems Management Functions 91