User guide

MR9600-100 User Guide
74 CommPlete Communications Server
upload
Parameter: Pathname
Description: Uploads from a computer connected to the MR9600 controller’s serial port connector the file
specified by
pathname . Before uploading, binary files must be converted to ASCII data on the source
computer using a utility supplied by Multi-Tech. The format for the data is one or more lines of
hexadecimal data up to 80 characters in length, where each hexadecimal value is bracketed by square
brackets (e.g., [2b][3c]...[1c]). When the file has been uploaded, press E
SC or CTRL+D to complete the
upload.
Note: For debugging use only under the direction of Technical Support personnel. Files will normally be
transferred using FTP.
Security: Supervisor
Limitations: Only ASCII files can be uploaded. This command does not support flow control, so the files
should be uploaded using an ASCII file transfer protocol with a 1 millisecond delay between lines.
Example:
[0] A:\MMM # upload mr9600.db
...data uploaded here...
2192 byte(s) written to ‘mr9600.db’
[1] A:\MMM #
uptime
Parameter: None
Description: Displays the date and time since the last boot. Displays in Days, hours, minutes and seconds
how long the system has been running.
Security: Operator
Example:
[05] A:\ # uptime
System up since – 12/18/1997 12:57pm - 0 Days 2 Hours 47 Minutes 15
Seconds
[06] A:\ #