User guide

MR9600-100 User Guide
70 CommPlete Communications Server
t1setup
Parameter: Device
Description: Sets the T1 configuration information associated with a T1 device. This information is stored
in a nonvolatile area of memory so that the device can be properly reconfigured on power-up or reset. The
specified device must be a T1 device. T1 devices can exist only at 1b, 1c, 5b, 5c, 9b, 9c, 13b, and 13c.
Security: Supervisor
Example:
[0] A:\MMM # t1setup 5b
T1 Card Status:
LED Information: None
Framing: AT&T D4 Super Frame (SF)
Line Coding: Alternate Mark Inversion (AMI)
FXS Signaling Options: E&M Immediate Start
Dial-in Address: DNIS
Acknowledgement Wink: Disabled
Transmit Level: - 7.5dB
Receive Level: - 0.0dB
Firmware Version: N/A
Framing Format
1. DS1 AT&T Extended Super Frame (ESF)
2. DS1 AT&T D4 Super Frame (SF)
3. DS1 ANSI Estended Super Frame
4. G.704.ITU-T section 2.1.3.2
5. G.704.ITU-T section 2.1.3.1
Enter Selection (1,<2>,3,4,5, q, -):
Line Coding
1. B8ZS
2. AMI
3. ZBTSI
Enter Selection (1,<2>,3, q, -):
Transmit Level
1. 0.0 dB
2. -7.5 dB
3. -15.0 dB
4. -22.5 dB
Enter Selection (1,<2>,3,4, q, -):
FXS Signaling Options
1. E&M Wink Start Conversion
2. E&M Immediate Start Conversion
3. Ground Start Standard
4. Loop Start Standard
Enter Selection (1,<2>,3,4, q, -):
Dial-in Address
1. No Address
2. DNIS
3. ANI-DNIS
4. ANI