User guide

1 Introduction
CommPlete Communications Server 5
Duplex Mode Jumpers
The MR9600-100 must be set to the proper duplex mode for all ports. To set the duplex mode, change the
Duplex Mode jumpers on the back of the MR9600-100. Note that it is not necessary to turn off the device
when changing the duplex mode setting.
Note: Full-duplex mode can only be used for connections to other switches or to
network stations. Connections to hubs must use half-duplex mode only.
MR9600-100 Controller Specifications
• Motorola MC68360 25 MHz microprocessor
• 8 MB of RAM for volatile storage
• 2 MB of flash memory: 1 MB for program space and 1 MB for nonvolatile file system space
• Recessed reset button
• Sixteen two-color LEDs for quick view of device card status
• Four Ethernet status LEDs
• Dimensions: 7.3 × 8.9 ×33.0 cm (H × W × D)
2.87
× 3.5 × 13 inches (H × W × D)
• Weight: 0.45 kg (1.0 lb.)
• Operating temperature: 0°–40° C (32°–104° F)
• Operating humidity: 0–95%, non-condensing (0-95%, storage)
• Operating altitude: 10,000 ft (3048 m)
• Power input: 100 ~ 240 VAC, 50/60Hz
• Power: 4.8 A @ 5 V
• Power Consumption: 15 watt (max.)
• Fuse: 7 A on 5 V supply
• Limited Warranty: Two years
Ethernet Switch Specifications
• Two high-speed uplink ports for connecting to a higher-tier switch or other device. The two RJ-45
100Base-T/10Base-TX connectors provide connection to a TCP/IP Ethernet network
• Full- and half-duplex capability on all ports; the five 10BaseT ports are user-configurable via the
Duplex Mode jumpers on the printed circuit board (PCB).
• One male DB-9 RS-232C diagnostic and configuration connector
• Six Ethernet utilization LEDs