User guide

MR9600-100 User Guide
4 CommPlete Communications Server
Ethernet Switch LEDs
The upper part of the MR9600-100 front panel contains 10 status indicators for the Ethernet switch.
LED Indicator Indication
UTILIZATION Percentage of bandwidth in use. Each LED that is on represents a
16.7% increment in use. The lower 4 LEDs are green, and the two
LEDs indicating highest activity are yellow.
CC9600 (LINK) On during a valid Ethernet link on a 10 Mbps port.
LAN (LINK)
CC9600 (100 MB)
LAN (100 MB)
On during a valid Ethernet link on a 10 Mbps LAN port.
On during a valid Ethernet link on a 100 Mbps port. Off during a 10M
bps connection.
On during a valid Ethernet link on a 100 Mbps LAN port. Off during a
10M bps connection.
Connectors
The MR9600-100 has three connectors that are accessible from the rear of the CC9600 chassis.
Figure 2. MR9600-100 connectors.
Connector Type Function
CC9600 RJ-45 Crossover 10/100M bps network connector. The transmit
and receive pairs of wires are swapped so the connector
can be used with a straight-through cable to connect the
CommPlete Communications Server to an external switch or
to the LAN connector on another CommPlete
Communications Server.
LAN RJ-45 Straight-through 10Base-T network connector. Use with a
straight-through cable to connect the CommPlete
Communications Server to a network card in a server, to a
network wall connector, or to the CC9600 connector on
another CommPlete Communications Server.
CONFIG PORT Male DB-9 RS-232C configuration port for MR9600-100 Controller.