User guide

63
Chapter 5 - Commands
The H7 Menu is as follws:
INTERNAL DSU COMMANDS
#DSUCL SELECTS CLOCKING FOR INTERNAL DSU.
#DSUSP SELECTS SPEED FOR INTERNAL DSU.
For HELP on a specific command, enter “ATH” followed by a command
letter.
The H8 Menu is as follows:
INTERNAL MMH2834 COMMANDS
$M(ASYNC/SYNC) SYNC OR ASYNC.
$M(DIAL/LEASED) DIAL UP OR LEASE LINE
$MWIRE(2/4) 2 OR 4 WIRE LEASE LINE
$MMTL(0/1) TRANSMIT LEVEL 1 OR -10DB
$M(ANSWER/ORIGINATE) ANSWER OR ORIGINATE
MODE FOR LEASED LINE
$MCOMMAND(0/1) ENABLE OR DISABLE
COMMAND MODE
$MTR(28800/91200
/1440/9600) DATA TRANSMISSION RATE
For HELP on a specific command, enter “ATH” followed by a command
letter.