User guide

172
Appendix J - Internal MMH2834 Composite Link Modem Commands
12 CONNECT 9600
13 CONNECT 14400
19 CONNECT 19200
21 CONNECT 21600
24 CONNECT 24000
26 CONNECT 26400
28 CONNECT 28800
AT&Q0 selects Multi-Tech responses with Reliable/
Compression modifiers. With this command, the terse result
code for CONNECT 2400 is 9.
TERSE VERBOSE
0OK
1 CONNECT
2 RING
3 NO CARRIER
4 ERROR
5 * CONNECT 1200
6 NO DIALTONE
7 BUSY
8 NO ANSWER
9 * CONNECT 2400
11 * CONNECT 4800
12 * CONNECT 9600
13 * CONNECT 14400
19 * CONNECT 19200
21 * CONNECT 21600
24 * CONNECT 24000
26 * CONNECT 26400
28 * CONNECT 28800
* When error correction is used, the word RELIABLE (verbose) or the letter R (terse) is added to these
responses. When data compression is used, the word COMPRESSED (verbose) or the letter C (terse) is
added to these responses
Result Codes The V command controls whether the MMH2834's result
(Verbose/Terse) MMH2834’s result codes are displayed as word (“verbose”) or
single digit (“terse”) messages.
V
For example, if after dialing, no carrier signal is detected, the
resulting message can be displayed either as NO CARRIER, or
as the digit 3.
Entering ATV0 (or ATV) causes the MMH2834 to display the
Result Codes as digits, while ATV1 displays them as words. If
you do not select a method, the factory default setting causes
the modem to display Result Codes as words.
Result Codes (BasicThe X Command is used to select one of two possible dialing
and Extended) and methods (""dumb or ""smart"), and to select various response